Cisco ONS 15454 Series Procedure Manual page 193

Chapter 6 Create Circuits and VT Tunnels
•
If you selected Fully Protected Path in
Step 14
click the Dual Ring Interconnect check box.
Click Next. In the Route Review and Edit area, node icons appear so you can route the circuit manually.
Step 15
The green arrows pointing from the selected node to other network nodes indicate spans that are
available for routing the circuit.
Step 16 Complete the
are creating.
Step 17 Click Finish.
Step 18 If you entered more than 1 in the Number of Circuits field, the Circuit Creation dialog box appears so
you can create the remaining circuits. Repeat Steps
Step 19 When all the circuits are created, the main Circuits window appears. Verify that the circuits you created
appear in the window.
Step 20 Complete the
test circuit.
Stop. You have completed this procedure.
NTP-A186 Create a Unidirectional DS-3 Circuit with Multiple
Drops
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
From the View menu, choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box, complete the following fields:
Step 5
•
•
•
August 2005
Link Diversity Only—Specifies that only fiber-diverse primary and alternate paths for path
protection portions of the complete circuit path are needed. The paths might be node-diverse, but
CTC does not check for node diversity.
"DLP-A96 Provision a DS-1 or DS-3 Circuit Route" task on page 17-97
"NTP-A135 Test Electrical Circuits" procedure on page
This procedure creates a unidirectional DS-3 circuit with multiple drops.
None
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A314 Assign a Name to a Port" task on page
Circuit Type—Choose STS.
Number of Circuits—Leave the default unchanged (1).
Auto-ranged—Unavailable when the Number of Circuits field is 1.
NTP-A186 Create a Unidirectional DS-3 Circuit with Multiple Drops
Step 12 and the circuit will be routed on a path protection DRI,
5 through 17
at the node where you will create the circuit.
Step 2.
Cisco ONS 15454 Procedure Guide, R5.0
for the DS-3 you
for each additional circuit.
6-36. Skip this step if you built a
20-8. If not, continue with Step 3.
6-25