Dlp- A330 Preprovision A Slot - Cisco ONS 15454 Series Procedure Manual

DLP-A330 Preprovision a Slot
DLP-A330 Preprovision a Slot
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, right-click the empty slot where you will later install a card.
Step 1
Step 2 From the Add Card shortcut menu, choose the card type that will be installed. Only cards that can be
installed in the slot appear in the Add Card shortcut menu.
Note
Return to your originating procedure (NTP).
Step 3
DLP-A332 Change Tunnel Type
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Step 2 Click the Provisioning > Overhead Circuits tabs.
Step 3 Click the circuit tunnel that you want to convert.
Click Edit.
Step 4
In the Edit circuit window, click the Tunnel tab.
Step 5
In the Attributes area, complete the following:
Step 6
•
Cisco ONS 15454 Procedure Guide, R5.0
20-20
This task preprovisions a card slot in CTC before you physically install the
card in the ONS 15454.
None
Chapter 3, "Connect the PC and Log into the GUI"
As needed
Onsite or remote
Provisioning or higher
When you preprovision a slot, the card appears purple in the CTC shelf graphic, rather than
white when a card is installed in the slot. NP (not present) on the card graphic indicates that the
card is not physically installed.
This task converts a traditional DCC tunnel to an IP-encapsulated tunnel or
an IP-encapsulated tunnel to a traditional DCC tunnel.
None
DLP-A313 Create a DCC Tunnel, page 20-7
DLP-A341 Create an IP-Encapsulated Tunnel, page 20-32
As needed
Onsite or remote
Provisioning or higher
If you are converting a traditional DCC tunnel to an IP-encapsulated tunnel, check the Change to
IP Tunnel check box and type the percentage of total SDCC bandwidth used in the IP tunnel (the
minimum percentage is 10 percent).
Chapter 20 DLPs A300 to A399
March 2005