Dlp- A347 Refresh E-Series And G-Series Ethernet Pm Counts - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Return to your originating procedure (NTP).
Step 11
DLP-A347 Refresh E-Series and G-Series Ethernet PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance > History tabs.
Step 2
From the Interval drop-down list, click one of the following:
Step 3
•
•
•
•
Step 4 Click Refresh. Performance monitoring appears in the interval selected, synchronized with the time of
day.
Step 5 View the Prev column to find PM counts for the latest selected interval.
Each monitored performance parameter has corresponding threshold values for the latest time period. If
the value of the counter exceeds the threshold value for a particular selected interval, a threshold crossing
alert (TCA) is raised. The number represents the counter value for each specific performance monitoring
parameter.
View the Prev-n columns to find PM counts for the previous intervals.
Step 6
Note
Return to your originating procedure (NTP).
Step 7
March 2005
1 min
15 min
1 hour
1 day
If a complete count over the selected interval is not possible, the value appears with a yellow
background. For example, if you selected the 1-day interval, an incomplete or incorrect count
can be caused by changing node timing settings, changing the time zone settings, monitoring for
less than 24 hours after the counter started, replacing a card, resetting a card, or changing port
service states. When the problem is corrected, the subsequent 1-day interval appears with a white
background.
DLP-A347 Refresh E-Series and G-Series Ethernet PM Counts
This task changes the window view to display E-Series and G-Series
Ethernet PM parameters intervals.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15454 Procedure Guide, R5.0
20-33