Cisco ONS 15454 Series Procedure Manual page 90

NTP-A15 Install the Common Control Cards
Table 2-1 Card and Slot Compatibility for the XCVT Card (continued)
Slot 1
Type MS
OC12 LR/STM4 X
LH 1310
OC12 LR/STM4 X
LH 1550
OC12 IR/STM4 Not supported with XCVT cards. Requires XC10G cards.
SH 1310-4
4
OC48 IR 1310
OC48 LR 1550
OC48 IR/STM16
SH AS 1310
OC48
LR/STM16 LH
AS 1550
OC48-ELR/STM
16 EH 100 GHz
OC48 ELR 200
GHz
OC192 Not supported with XCVT cards. Requires XC10G cards.
SR/STM64 IO
1310
OC192 Not supported with XCVT cards. Requires XC10G cards.
IR/STM64 SH
1550
OC192 Not supported with XCVT cards. Requires XC10G cards.
LR/STM64 LH
1550
OC192 Not supported with XCVT cards. Requires XC10G cards.
LR/STM64 LH
ITU 15xx.xx
FC_MR-4
1. This identifies 1:N cards that operate as normal DS1 or DS3 cards when installed in certain slots.
2. This DS3 card cannot be used in this slot if used with a high-density EIA or in a 1:N configuration.
3. This card can only be used with the XCVT card, not the XC card.
4. The OC48AS will operate in Slots 5, 6, 12, and 13 with the XC/XCVT in R3.4 through R4.6, and the OC48AS will operate in Slots 5, 6, 12, and 13 with
the XCVT in R5.0 and later. In Release R3.3 and earlier, OC48AS with XC/XCVT is not supported.
In Table
through 17 (multispeed slot). HS identifices Slots 5, 6, 12, and 13 (high-speed slot). The XC10G card
requires the ANSI shelf (5454-SA-ANSI) or the high-density shelf (15454-SA-HD).
Cisco ONS 15454 Procedure Guide, R5.0
2-4
2 3 4 5 6
MS MS MS HS HS
X X X X X
X X X X X
X X
X X
X X
X X
X X
X X
X X
2-2, X indicates that a card is supported in the slot. MS identifies Slots 1 through 4 and 14
7 8 9 10 11
TCC XC AIC XC TCC HS
Chapter 2 Install Cards and Fiber-Optic Cable
12 13 14 15
HS MS MS
X X X X
X X X X
X X
X X
X X
X X
X X
X X
X X
16 17
MS MS
X X
X X
May 2006