Dlp- A257 View Ethernet Utilization Pm Parameters - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
Figure 19-4
Card View
Performance
Statistics tab
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 3
View the PM parameter names appear in the Param column. The current PM parameter values appear in
Step 4
the Port # columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 Troubleshooting Guide.
Note
Return to your originating procedure (NTP).
Step 5
DLP-A257 View Ethernet Utilization PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
September 2005
G-Series Statistics on the Card View Performance Window
tab
Refresh
button
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task enables you to view line utilization PM counts on an Ethernet
card and port to detect possible performance problems.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
DLP-A257 View Ethernet Utilization PM Parameters
Auto-refresh Baseline
menu button
"NTP-A253 Change the PM Display" procedure
Cisco ONS 15454 Procedure Guide, R5.0
Clear Help
button button
19-39