Dlp- A314 Assign A Name To A Port - Cisco ONS 15454 Series Procedure Manual

DLP-A314 Assign a Name to a Port
•
•
•
Click Finish.
Step 8
Put the ports that are hosting the DCC tunnel in service. See the
Step 9
for a Port" task on page 19-9
Return to your originating procedure (NTP).
Step 10
DLP-A314 Assign a Name to a Port
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Double-click the card that has the port you want to provision.
Step 1
Click the Provisioning tab.
Step 2
Click the Port Name column for the port number to which you are assigning a name.
Step 3
Type the port name.
Step 4
The port name can be up to 32 alphanumeric/special characters. The field is blank by default.
Step 5 Click Apply.
Step 6 Return to your originating procedure (NTP).
Cisco ONS 15454 Procedure Guide, R5.0
20-8
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
Channel—These options appear if you chose DCC Tunnel-D1-D3 as the tunnel type. Choose one of
the following:
DCC1 (D1-D3)—This is the SDCC.
–
DCC2 (D4-D6)—This is LDCC 1.
–
DCC3 (D7-D9)—This is LDCC 2.
–
– DCC4 (D10-D12)—This is LDCC 3.
DCC options do not appear if they are used by the ONS 15454 (DCC1) or other tunnels.
for instructions.
This task assigns a name to a port on any ONS 15454 card.
None
NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Chapter 20 DLPs A300 to A399
"DLP-A214 Change the Service State
March 2005