Dlp- A173 Change External Alarms Using The Aic Card - Cisco ONS 15454 Series Procedure Manual

DLP-A173 Change External Alarms Using the AIC Card
DLP-A173 Change External Alarms Using the AIC Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Confirm that external-device relays are wired to the ENVIR ALARMS IN backplane pins. See the
Step 1
"DLP-A19 Install Alarm Wires on the Backplane" task on page 17-22
In node view, double-click the AIC card to display it in card view.
Step 2
Click the Provisioning > External Alarms tabs.
Step 3
Modify any of the following fields for each external device wired to the ONS 15454 backplane. For
Step 4
definitions of these fields, see the
Interface Controller" procedure on page
•
•
•
•
•
•
To provision additional devices, complete Step
Step 5
Click Apply.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-A174 Change External Controls Using the AIC Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify the external control relays to the ENVIR ALARMS OUT backplane pins. See the
Step 1
Install Alarm Wires on the Backplane" task on page 17-22
In node view, double-click the AIC card to display it in card view.
Step 2
Cisco ONS 15454 Procedure Guide, R5.0
18-54
This task changes external alarm settings on the Alarm Interface Controller
(AIC) card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Enabled
Alarm Type
Severity
Virtual Wire
Raised When
Description
This task changes external control settings on the AIC card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
"NTP-A32 Provision External Alarms and Controls on the Alarm
7-9.
4 for each additional device.
for more information.
Chapter 18 DLPs A100 to A199
for more information.
"DLP-A19
March 2007