Dlp- A387 Change Line And Threshold Settings For The Ds3Xm-12 Card - Cisco ONS 15454 Series Procedure Manual

DLP-A387 Change Line and Threshold Settings for the DS3XM-12 Card
DLP-A387 Change Line and Threshold Settings for the DS3XM-12 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The DS3XM-12 (transmux) card can accept up to 12 channelized DS-3 signals and convert each signal
Note
to 28 VT1.5 signals for a total of 336 VT1.5 conversions. Conversely, the card can take 28 VT1.5s and
multiplex them into a channeled C-bit or M13 framed DS-3 signal for each of the 12 DS-3 ports.
In node view, double-click the DS3XM-12 card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
Depending on the setting you need to modify, click the Line, DS1, Line Thresholds,
Step 3
Elect Path Thresholds, or SONET Thresholds tab.
Note
Modify any of the settings found under these subtabs. For definitions of the Line settings, see
Step 4
For definitions of the DS1 settings, see
settings, see
Table 20-6 on page
page
Click Apply.
Step 5
Repeat Steps
Step 6
Table 20-3
Table 20-3
Parameter
Port #
Port Name
SF BER
Cisco ONS 15454 Procedure Guide, R5.0
20-74
This task changes the line and threshold settings for the DS3XM-12 card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
See Chapter 7, "Manage Alarms"
Table 20-5 on page
20-78. For definitions of the SONET Threshold settings, see
20-80.
3 through 5 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS3XM-12 cards.
Line Options for the DS3XM-12 Parameters
Description
(Display only.) Displays the port number. 1 to 36
Displays the port name.
Sets the signal fail bit error rate.
for information about the Alarm Profiles tab.
Table 20-4 on page
20-77. For definitions of the Electrical Path Threshold settings, see
Chapter 20
20-76. For definitions of the Line Threshold
Table 20-7 on
Options
User-defined, up to 32 alphanumeric/
special characters. Blank by default.
See the "DLP-A314 Assign a Name to a
Port" task on page 20-8.
• 1E-3
• 1E-4
1E-5
•
DLPs A300 to A399
Table 20-3.
March 2005