Figure 22-5 E-Series Card Alarm Profile - Cisco ONS 15454 Series Procedure Manual

Chapter 22 DLPs A500 to A599
In the node view, double-click a card to open the card view.
Step 1
Note
Note
Step 2 Depending on which card you want to apply the profile to, click the following tabs:
• If the card is an FC_MR-4, E-Series Ethernet, G-Series Ethernet, OC-N, or electrical (DS-1, DS-1N,
DS-3, DS-3E, DS3i, DS3i-N, DS-3N, DS-3NE, DS3XM, or EC-1) card, click the Provisioning >
Alarm Profiles > Alarm Profiles tabs.
If the card is an ML-Series Ethernet (traffic) card, click the Provisioning > Ether Alarming >
•
Alarm Behavior tabs to apply the profile to the front physical ports, or the Provisioning >
POS Alarming > Alarm Behavior tabs to apply the profile to the POS ports. For more information
about ML-Series card ports and service, see the Ethernet Card Software Feature and Configuration
Guide for the Cisco ONS 15454 SDH, Cisco ONS 15454, and Cisco ONS 15327.
Figure 22-5
card profile is Inherited.
Figure 22-5
Go to
Step 3 To apply profiles on a port basis:
In card view, click the port row in the Profile column.
a.
Choose the new profile from the drop-down list.
b.
Click Apply.
c.
October 2005
You can also apply alarm profiles to cards using the
and Nodes" task on page
The card view is not available for the TCC2/TCC2P or cross-connect cards.
shows the alarm profile for the ports of an E-Series Ethernet card. CTC shows that the parent
E-Series Card Alarm Profile
Step 3 to apply profiles to a port. Go to
18-5.
Step 4 to apply profiles to all ports on a card.
Cisco ONS 15454 Procedure Guide, R5.0
DLP-A519 Apply Alarm Profiles to Ports
"DLP-A117 Apply Alarm Profiles to Cards
22-13