Displaying Ml-Series Pos Ports Provisioning Information On Ctc - Cisco ONS 15454 SDH Configuration Manual

Chapter 2 CTC Operations
Table 2-2
Column
Speed
Duplex
Flow
Control
Optics
The 100 FX value in the Optics column of the ML100X-8 represent the short wavelength (SX) SFP.
Note
The port name field configured in CTC and the port name configured in Cisco IOS are independent of
Note
each other. The name for the same port under Cisco IOS and CTC does not match, unless the same name
is used to configure the port name in both CTC and Cisco IOS.
Displaying ML-Series POS Ports Provisioning Information on
CTC
The POS ports provisioning window displays the provisioning status of the card's POS ports. Click the
Provisioning > POS Ports tabs to display this window.
The user must configure ML-Series ports using the Cisco IOS CLI; however, the following fields can be
provisioned using CTC: Port Name, Pre-Service Alarm Suppression (PSAS), and Soak Time. Click the
Port Name field to assign a name to the port. For more information about provisioning these fields, refer
to the "Change Card Settings" chapter in the Cisco ONS 15454 Procedure Guide.
Table 2-3
Table 2-3
Column
Port
Port Name
Admin State
Link State
CTC Display of Ethernet Port Provisioning Status (continued)
Description
Ethernet port transmission speed.
Setting of the duplex mode for the port. —
Flow control mode negotiated with peer
device. These values are displayed but
not configurable in CTC.
Small form-factor pluggable (SFP)
physical media type.
details the information displayed under the Provisioning > POS Ports tab.
CTC Display of POS Port Provisioning Status
Description
The fixed number identifier for the specific port.
Configurable 12-character alphanumeric identifier for the port.
Configured port state, which is administratively active or inactive. Possible
values are UP and DOWN. For the UP value to appear, a POS port must be
both administratively active and have a SONET/SDH circuit provisioned.
Status between signaling points at port and attached device. Possible values
are UP and DOWN.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0

Displaying ML-Series POS Ports Provisioning Information on CTC

ML1000-2 ML100T-12
— Auto,
10Mbps, or
100Mbps
Auto, Full, or
Half
Asymmetrical, Symmetrical
Symmetrical or or None
None
Unplugged, —
1000 SX, or
1000 LX
ML100X-8
100Mbps
Full
Symmetrical
or None
Unplugged,
100 FX, or
100 LX
2-3