Table 2-1 Ml-Series Pos And Ethernet Statistics Fields And Buttons; Table 2-2 Ctc Display Of Ethernet Port Provisioning Status; Chapter 2 Ctc Operation - Cisco ONS 15454 SDH Configuration Manual

Displaying ML-Series Ethernet Ports Provisioning Information on CTC
Table 2-1
Button
Refresh
Baseline
Auto-Refresh
Displaying ML-Series Ethernet Ports Provisioning Information
on CTC
The Ethernet port provisioning window displays the provisioning status of the Ethernet ports. Click the
Provisioning > Ether Ports tabs to display this window.
The user must configure ML-Series ports using the Cisco IOS CL; however, the following fields can be
provisioned using CTC: Port Name, Pre-Service Alarm Suppression (PSAS), and Soak Time. Click the
Port Name field to assign a name to the port. For more information about provisioning these fields, refer
to the "Change Card Settings" chapter in the Cisco ONS 15454 Procedure Guide.
"Auto" in a column indicates the port is set to autonegotiate capabilities with the attached link partner.
All ML-Series cards do not display all columns.
Provisioning > Ether Ports tab:
Table 2-2
Column
Port
Port Name
Admin State Configured port state, which is
Link State
PSAS
Soak Time
MTU
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
2-2
ML-Series POS and Ethernet Statistics Fields and Buttons
Description
Manually refreshes the statistics.
Resets the software counters (in that particular CTC client only) temporarily to zero
without affecting the actual statistics on the card. From that point on, only counters
displaying the change from the temporary baseline are displayed by this CTC client.
These new baselined counters are shown only as long as the user displays the
Performance window. If the user navigates to another CTC window and comes back
to the Performance window, the true actual statistics retained by the card are shown.
Sets a time interval for the automatic refresh of statistics.
CTC Display of Ethernet Port Provisioning Status
Description
The fixed number identifier for the
specific port.
Configurable 12-character
alphanumeric identifier for the port.
administratively active or inactive.
Status between signaling points at port
and attached device.
A check indicates alarm suppression is set on the port for the time designated in the
Soak Time column.
Desired soak time in hours and minutes. Use this column when you have checked PSAS
to suppress alarms. Once the port detects a signal, the countdown begins for the
designated soak time. Soak time hours can be set from 0 to 48. Soak time minutes can
be set from 0 to 45 in 15 minute increments.
(Maximum Transmission Unit) Largest
acceptable packet size configured for
that port.
Table 2-2 details the information displayed under the
ML1000-2 ML100T-12
0 or 1 0-11
User specific User specific
UP and DOWN UP and
DOWN
UP and DOWN UP and
DOWN
Default value is Default value
1500 is 1500
Chapter 2 CTC Operations
ML100X-8
0-7
User
specific
UP and
DOWN
UP and
DOWN
Default
value is
1500