ENGINE GENERAL INFORMATION AND DIAGNOSIS (J18 ENGINE WITH WU TWC) 6-2-31
INSPECTION OF ECM AND ITS CIRCUITS
ECM and its circuits can be checked at ECM wiring couplers by
measuring voltage and resistance.
CAUTION:
ECM cannot be checked by itself. It is strictly prohibited
to connect voltmeter or ohmmeter to ECM with coupler
disconnected from it.
VOLTAGE CHECK
1) Remove ECM (1) from body referring to Section 6E2.
2) Check voltage at each terminal of couplers (2) connected.
NOTE:
As each terminal voltage is affected by the battery voltage,
confirm that it is 11 V or more when ignition switch is ON.
3. Body ground
1. ECM
2. ECM couplers (Viewed from harness side)