SFI (1GR−FE)
−
ACCELERATOR PEDAL POSITION SENSOR
ACCELERATOR PEDAL POSITION
SENSOR
INSPECTION
1.
INSPECT ACCELERATOR PEDAL POSITION SEN-
SOR
(a)
Connect the hand−held tester to the DLC3.
(b)
Turn the ignition switch to the ON position.
(c)
Check if the voltage (ACCEL POS) of the CURRENT
DATA indicates the standard value.
Accelerator pedal released: 0.5 to 1.1 V
Accelerator pedal depressed: 2.6 to 4.5 V
(d)
Check if the voltage (ACCEL POS #2) of the CURRENT
DATA indicates the standard value.
Accelerator pedal released: 1.2 to 2.0 V
Accelerator pedal depressed: 3.4 to 5.3 V
If not using a hand−held tester, measure the voltage between
terminals (VPA − EPA, VPA2 − EPA2) of the ECM connector
(see page DI−34).
2.
REMOVE ACCELERATOR PEDAL ROD
(a)
Disconnect the accelerator pedal connector.
(b)
Remove the 2 nuts and the accelerator pedal assy.
3.
INSTALL ACCELERATOR PEDAL ROD
NOTICE:
S
Avoid physical shock to the accelerator pedal assy.
S
Do not disassemble the accelerator pedal assy.
(a)
Install the accelerator pedal assy with the 2 nuts.
Torque: 5.0 N m (51 kgf cm, 44 in. lbf)
A23406
(b)
Connect the accelerator pedal connector.
SF−65
SF1ZE−01