Toyota Tundra 2005 Service - Repair - Maintenance page 1969

(c)
Throttle Body Cover Bracket
Clamp
Clamp
SFI (2UZ−FE) −
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
(See page SF−1)
2. REMOVE THROTTLE BODY COVER
3. REMOVE INTAKE AIR CONNECTOR
4. REMOVE FUEL PRESSURE PULSATION DAMPER
Remove the pulsation damper, upper gasket, fuel main hose
and lower gasket.
NOTICE:
S
Put a shop rag under the delivery pipe.
S
Slowly loosen the pulsation damper.
5. DISCONNECT PCV HOSE FROM PCV VALVE
B07312
6. DISCONNECT VSV FOR EVAP
(a) Disconnect the VSV connector for EVAP.
(a)
(b) Disconnect the EVAP hose.
(b)
(c) Remove the VSV for EVAP from the intake manifold.
7. REMOVE THROTTLE BODY COVER BRACKET
Remove the bolt and throttle body cover bracket.
B16540
8. DISCONNECT ENGINE WIRES
Clamp
(a) Disconnect the engine wire clamps from the No.1 engine
hanger and engine wire bracket.
(b) Disconnect the 2 wire clamps on the engine wire from the
brackets on the RH delivery pipe.
9. REMOVE DELIVERY PIPES AND INJECTORS
NOTICE:
S
Be careful not to drop the injectors when removing
the delivery pipes.
B07045
S
Do not apply any load to the injector in horizontal
direction.
INJECTOR
SF−27
SF133−09