Toyota Tundra 2005 Service - Repair - Maintenance page 2007

Hide thumbs Also See for Tundra 2005:

Table of Contents

No Continuity

SFI (2UZ−FE)

VSV FOR EVAPORATIVE EMISSION (EVAP)

Inspect the VSV for open circuit.

Using an ohmmeter, check that there is continuity be-

tween the terminals.

Resistance: 30 to 34 Ω at 20°C (68°F)

If there is no continuity, replace the VSV.

Inspect the VSV for ground.

Using an ohmmeter, check that there is no continuity be-

tween each terminal and the body.

If there is continuity, replace the VSV.

Inspect the VSV operation.

Check that air dose not flow from port.

Apply battery positive voltage across the terminals.

Check that air flows from port.

If operation is not as specified, replace the VSV.

REINSTALL VSV