Toyota Tundra 2005 Service - Repair - Maintenance page 1971

Pressure Regulator
SST
SST
Injector
Pressure Regulator
SST (Union)
Fuel Return Hose
SST
(Adaptor)
O−Ring
Vinyl
Hose
CAN VIM
DLC3
SFI (2UZ−FE)
INSPECTION
1.
SST
CAUTION:
Keep the injector clean of sparks during the test.
(a)
SST
(b)
B07326
(c)
(d)
(e)
SST (Hose)
(f)
B04988
(g)
SST
(h)
(Hose)
(i)
SST
CAUTION:
(Clamp)
Install a suitable vinyl hose onto the injector to prevent
gasoline from splashing out.
B00884
(j)
Hand−Held Tester
(k)
(l)
NOTICE:
Do not start the engine.
(m)
D13872
(n)
− INJECTOR
INSPECT INJECTOR INJECTION
Disconnect the fuel inlet hose (fuel tube connector) from
the fuel filter.
Connect SST (attachment and hose) to the fuel tube.
SST 09268−41047 (09268−52011)
Remove the pressure regulator from the delivery pipe.
Install the O−ring to the fuel inlet of the pressure regulator.
Connect SST (hose) to the fuel inlet of the pressure regu-
lator with SST (union) and the 2 bolts.
SST 09268−41047 (09268−41091)
Torque: 7.5 N·m (76 kgf·cm, 66 in.·lbf)
Connect the fuel return hose to the fuel outlet of the pres-
sure regulator.
Install the O−ring to the injector.
Connect SST (adaptor and hose) to the injector, and hold
the injector and union with SST (clamp).
SST 09268−41047 (09268−41110, 09268−41300)
Put the injector into the graduated cylinder.
Connect a hand−held tester to the Controller Area Net-
work Vehicle Interface Module (CAN VIM). Then connect
the CAN VIM to the Date Link Connector 3 (DLC3).
Connect the battery negative (−) cable to the battery.
Turn the ignition switch ON, and push the hand−held tes-
ter main switch ON.
Enter the following menus: DIAGNOSIS / ENHANCED
OBDII / ACTIVE TEST / FUEL PUMP / SPD
Please refer to the hand−held tester operator's manual
for further details.
SF−29
SF134−04