Intel Arria 10 User Manual page 555

6. Reconfiguration Interface and Dynamic Reconfiguration
UG-01143 | 2018.06.15
1. Perform the necessary steps from steps 1 to 7 in Steps to Perform Dynamic
Reconfiguration.
2. Perform a read-modify-write to address 0x006 according to
Generators for bonded and non bonded
3. Perform a read-modify-write to address 0x007 according to
Generators for bonded and non bonded
4. Perform a read-modify-write to address 0x008 according to
Generators for bonded and non bonded
5. Perform a read-modify-write to address 0x110 with the specified width. This data
width is either 64-bit or 10-bit.
6. Perform a read-modify-write to address 0x111 according to
Generators for bonded and non bonded
in the register 0x111[5:0] before changing the
xN non bonding.
7. Perform the necessary steps from steps 9 to 12 in Steps to Perform Dynamic
Reconfiguration.
To disable the PRBS generator, write the original values back into the read-modify-
write addresses in
designs.
6.16.1.2.1. Examples of Enabling the PRBS9 and PRBS31 Pattern Generators in bonded
designs
Example 7. Enabling the PRBS9 pattern generator in 10-bit mode
1. Perform the necessary steps from steps 1 to 7 in Steps to Perform Dynamic
Reconfiguration.
2. Perform a read-modify-write to address x006[7:0] with the following bits: 8'b01- -
1100
3. Perform a read-modify-write to address x007[7:0] with the following bits: 8'b0010
- - - -
4. Perform a read-modify-write to address x008[7:0] with the following bits: 8'b -
000 - - - -
5. Perform a read-modify-write to address x110[7:0] with the following bits: 8'b - - -
- - 100
6. Perform a read-modify-write to address x111[5:0] with the following bits:
8'b---11000. You must read and save the value in the register 0x111[5:0] before
changing the
7. Perform the necessary steps from steps 9 to 12 in Steps to Perform Dynamic
Reconfiguration.
Note: A dash (-) indicates that the corresponding bit value should not be modified during
read-modify-write.
Register Map for PRBS Generators for bonded and non bonded
x1_clock_source_sel
Register Map for PRBS
designs.
Register Map for PRBS
designs.
Register Map for PRBS
designs.
Register Map for PRBS
designs. You must read and save the value
x1_clock_source_sel
setting to xN non bonding.
® ®
Intel Arria 10 Transceiver PHY User Guide
setting to
555