Intel Arria 10 User Manual page 540

Table 283. Analog PMA Settings (Optional) for Dynamic Reconfiguration
The following parameters are available in the Analog PMA Settings (Optional) tab of the Transceiver Native
PHY parameter editor. Refer to Changing PMA Analog Parameters for more details. Refer to the Analog
Parameter Settings chapter for details about using the QSF assignments.
Parameter
TX Analog PMA Settings
Analog Mode (Load Intel-
recommended Default
settings)
Override Intel-recommended
Analog Mode Default settings
Output Swing Level (VOD)
Pre-Emphasis First Pre-Tap
Polarity
Pre-Emphasis First Pre-Tap
Magnitude
Pre-Emphasis Second Pre-Tap
Polarity
Pre-Emphasis Second Pre-Tap
Magnitude
Pre-Emphasis First Post-Tap
Polarity
Pre-Emphasis First Post-Tap
Magnitude
Pre-Emphasis Second Post-
Tap Polarity
Pre-Emphasis Second Post-
Tap Magnitude
Slew Rate Control
High-Speed Compensation
On-Chip termination
RX Analog PMA settings
Override Intel-recommended
Default settings
CTLE (Continuous Time Linear
Equalizer) mode
® ®
Intel Arria 10 Transceiver PHY User Guide
540
6. Reconfiguration Interface and Dynamic Reconfiguration
Value
cei_11100_lr to Selects the analog protocol mode to pre-select the TX pin
xfp_9950 swing settings (VOD, Pre-emphasis, and Slew Rate). After
loading the pre-selected values in the Parameter Editor, if
one or more of the individual TX pin swing settings need to
be changed, then enable the option to override the Intel-
recommended defaults to individually modify the settings.
For details about QSF assignments for the analog settings,
refer to the Analog Parameter Settings chapter.
On / Off Enables the option to override the Intel-recommended
settings for the selected TX Analog Mode for one or more TX
analog parameters.
0-31 Selects the transmitter programmable output differential
voltage swing.
Fir_pre_1t_neg, Selects the polarity of the first pre-tap for pre-emphasis.
Fir_pre_1t_pos
0-16 Selects the magnitude of the first pre-tap for pre-emphasis.
Fir_pre_2t_neg, Selects the polarity of the second pre-tap for pre-emphasis.
Fir_pre_2t_pos
0-7 Selects the magnitude of the second pre-tap for pre-
emphasis.
Fir_post_1t_neg, Selects the polarity of the first post-tap for pre-emphasis.
Fir_post_1t_pos
0-25 Selects the magnitude of the first post-tap for pre-
emphasis.
Fir_post_2t_neg, Selects the polarity of the second post-tap for pre-
Fir_post_2t_pos emphasis.
0-12 Selects the magnitude of the second post-tap for pre-
emphasis.
slew_r0 to slew_r5 Selects the slew rate of the TX output signal. Valid values
span from slowest to the fastest rate.
Enable / Disable Enables the power-distribution network (PDN) induced inter-
symbol interference (ISI) compensation in the TX driver.
When enabled, it reduces the PDN induced ISI jitter, but
increases the power consumption.
r_r1, r_r2 Selects the on-chip TX differential termination.
On / Off Enables the option to override the Intel-recommended
settings for one or more RX analog parameters. For details
about QSF assignments for the analog settings, refer to the
Analog Parameter Settings chapter.
non_s1_mode, Selects between the RX high gain mode (non_s1_mode) or
s1_mode RX high data rate mode (s1_mode) for the Continuous Time
Linear Equalizer (CTLE).
UG-01143 | 2018.06.15
Description
continued...