Intel Arria 10 User Manual page 276

The Root Port decodes these coefficients and presets, performs legality checks for
the three transmitter coefficient rules and applies the settings to its transmitter
and also sends them in the Training Sets. The default Full Swing (FS) value
advertised by the Intel device is 60 and Low Frequency (LF) is 20. The three rules
for transmitter coefficients are:
a. |C
b. |C
c. C
Where: C
the post-cursor (de-emphasis).
3. This process is repeated until the downstream component's receiver achieves a
BER of < 10
Phase 3 (Optional)
During this phase, the Root Port tunes the Endpoint's transmitter. This process is
analogous to Phase 2 but operates in the opposite direction.
After Phase 3 tuning is complete, the Root Port moves to Recovery.RcvrLock, sending
EC=2'b00, and the final coefficients or preset agreed upon in Phase 2. The Endpoint
moves to Recovery.RcvrLock using the final coefficients or preset agreed upon in
Phase 3.
Recommendations for Tuning Link
To improve the BER of the receiver, Intel recommends that you turn on CTLE in
triggered mode during Phase 2 Equalization for Endpoints or Phase 3 Equalization for
Root Ports.
Use the port
to the Gen3 presets. Intel recommends transmitting Preset P8 coefficients for A10
receiver to recover data successfully. The
link partner's transmitter de-emphasis during equalization.
Use the port
during equalization phases.
Table 196. CTLE mode for Gen1/Gen2 speeds of Gen3 capable design
Use this table to drive the
Gen1/Gen2 speeds of a Gen3 capable design.
Gen3 capable design running at Gen1/Gen2
speeds during
Power up
Down train to Gen1/Gen2 (directed or not) and
subsequent re-entry to Gen3
Down train to Gen1/Gen2
® ®
Intel Arria 10 Transceiver PHY User Guide
276
| <= Floor (FS/4)
-1
|+C +|C | = FS
-1 0 +1
-|C |-|C |>= LF
0 -1 +1
is the main cursor (boost), C
0
-12
pipe_g3_txdeemph[17:0]
pipe_g3_rxpresethint[2:0]
pipe_g3_rxpresethint
Supported CTLE - mode Manual. To use CTLE in manual mode
•
•
•
•
•
•
•
•
•
2. Implementing Protocols in Arria 10 Transceivers
is the pre-cursor (pre-shoot), and C
-1
to transmit the coefficients corresponding
pipe_g3_txdeemph
to turn on CTLE in triggered mode
port and set the CTLE in manual mode when operating at
During power up, set
pipe_g3_rxpresethint[2:0]
You can use the default CTLE 4S AC Gain set by Quartus (or)
Set the manual CTLE 4S AC Gain using QSF assignments
On entry to Gen1/2, set
pipe_g3_rxpresethint[2:0]
You can use the default CTLE 4S AC Gain set by Quartus (or)
Set the manual CTLE 4S AC Gain using QSF assignments
On entry to Gen1/2, set
pipe_g3_rxpresethint[2:0]
You can use the default CTLE 4S AC Gain set by Quartus (or)
Set the manual CTLE 4S AC Gain using QSF assignments
UG-01143 | 2018.06.15
is
+1
is used to select the
= 3'b000
= 3'b000
= 3'b000