005-916 Cvt Aps No2 Sensor Static Jam Rap - Xerox WorkCentre 5222 Service Manual

005-916 CVT APS No2 Sensor Static JAM RAP

Paper remains on the APS Sensor 2.
Initial Actions
• Refer to BSD 5.4.
• Remove the paper.
Procedure
Execute Component Control[005-219 DADF APS 2 Sensor]]. Actuate the DADF APS 2 Sensor
with paper. The display changes.
Y N
Check the connections of P/J778 and P/J761.
rectly.
Y N
Connect P/J778 and P/J761.
Check the wire between J778 and J761 for an open circuit or a short circuit (BSD 5.4
9/Flag 10). The wire between J778 and J761 is conducting without an open circuit
or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P761-1 (+) and GND (-) (BSD 5.4
10). The voltage is approx. +5VDC.
Y N
Replace the DADF PWB (PL 15.3).
Measure the voltage between the DADF PWB P761-3 (+) and GND (-) (BSD 5.4
Actuate the DADF APS 2 Sensor with paper. The voltage changes.
Y N
Replace the DADF APS 2 Sensor
Replace the DADF PWB (PL 15.3).
Replace the DADF PWB (PL 15.3).
Status Indicator Raps
005-916
P/J778 and P/J761 are connected cor-
(PL 15.7).
Flag
Flag
Flag 9).
February, 2008
2-86
Launch Version
WorkCentre 5225, 5230