5-197 Dadf Registration Sensor Static Jam Rap; 5-198 Dadf Exit Sensor Static Jam Rap - Xerox DocuColor 12/DCCS50 Service Manual

5-197 DADF Registration Sensor Static Jam RAP

The DADF Registration Sensor has detected the presence of a document after the power was
switched on and the DADF Top Cover was closed.
Initial Actions
Check for the following:
• Ensure that no documents remain in the DADF.
• Contamination on the DADF Registration Sensor.
• Ensure that connectors P/J599 and
PWB and DADF Registration Sensor and there are no obvious crimped or broken wires.
• Refer to BSD 5.3 for the following procedure.
Procedure
Enter dC330 005-110 Regi Sensor. Press Start. The display is L.
Y N
+5 VDC is measured between P/J599-2 and GND on the DADF Control PWB.
Y N
Flag 1 on BSD 5.3.Check the wire for a short circuit to ground. If the wire is
Go to
good, replace the DADF Registration Sensor
Replace the DADF Control PWB (PL
The problem appears to be intermittent. Replace the DADF Registration Sensor
the problem continues, replace the DADF Control PWB
Status Indicator RAPs
5-197 DADF Registration Sensor Static Jam RAP, 5-
P/J580 are seated correctly on the DADF Control
(PL 12.5).
12.3).
(PL
(PL 12.3).

5-198 DADF Exit Sensor Static Jam RAP

The DADF Exit Sensor has detected the presence of a document after the power was switched
on and the DADF Top Cover was closed.
Initial Actions
Check for the following:
• Ensure that no documents remain in the DADF.
• Contamination on the DADF Exit Sensor.
• Ensure that connectors
PWB and DADF Exit Sensor and there are no obvious crimped or broken wires.
• Refer to BSD 5.5 for the following procedure.
Procedure
Enter dC330 005-115 Exit Sensor. Press Start. The display is L.
Y N
+5 VDC is measured between P/J599-19 and GND on the DADF Control PWB.
Y N
Flag 1 on BSD 5.5.Check the wire for a short circuit to ground. If the wire is
Go to
good, replace the DADF Exit Sensor
Replace the DADF Control PWB
12.5). If The problem appears to be intermittent. Replace the DADF Exit Sensor
lem continues, replace the DADF Control PWB
1/05
2-46
manuals4you.com manuals4you.com
P/J599 and P/J589 are seated correctly on the DADF Control
(PL 12.9).
(PL 12.3).
(PL 12.3).
DocuColor 12/DCCS50
(PL 12.9). If the prob-
Reissue