Stapler/Punch Concurrence Rap - Xerox VersaLink B7025 Service Manual

024-968 Stapler/Punch Concurrence RAP

BSD-ON: BSD 13.6 Office Finisher LX Punch
024-968 Staple position and punch position are the same.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check if the specified paper is loaded in the tray.
• Switch off, then switch on the machine,
Procedure
Cancel staple mode and punch mode. The fault persists.
Y N
Correct the settings.
Check the connectors on the finisher PWB. The connectors are securely connected.
Y N
Connect the connectors securely.
Check the connection of the harness between the machine and the finisher. The harness is
securely connected.
Y N
Connect the harness securely.
Perform the steps that follow:
1. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
2. Reload the software, GP 4.
3. If the fault persists, install a new finisher PWB,
or PL 13.45 Item 2 (office finisher LX).
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10.
PL 1.10 Item 3 and the ESS PWB,
PL 12.14 Item 1 (integrated office finisher)
024-969 Different Width Mix Punch RAP
BSD-ON: BSD 13.6 Office Finisher LX Punch
024-969 Mixed punch paper of different widths was detected while printing in punch mode.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
• Check if the specified paper is loaded in the tray.
• Switch off, then switch on the machine,
Procedure
Cancel punch mode. The fault persists.
Y N
Correct the settings.
Check the connectors on the finisher PWB. The connectors are securely connected.
Y N
Connect the connectors securely.
Check the connection of the harness between the machine and the finisher. The harness is
securely connected.
Y N
Connect the harness securely.
Perform the steps that follow:
PL 3.10 1. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
2. Reload the software, GP
3. If the fault persists, install a new finisher PWB,
or PL 13.45 Item 2 (office finisher LX).
April 2017
2-329
WARNING
GP 10. Disconnect the power cord. Electricity can cause
GP 10.
PL 1.10 Item 3 and the ESS PWB,
4.
PL 12.14 Item 1 (integrated office finisher)
024-968, 024-969
PL 3.10
Status Indicator RAPs