Table of Contents
Advertisement
Replacement
1.
Reverse the removal procedure to replace the hole punch unit, motor assembly and sen-
sors.
2.
If necessary, perform
ADJ 12.3-110
NOTE: When installing the hole punch motor assembly, ensure that the belt tensioner arm
does not get trapped behind the motor assembly plate.
ColorQube® 9303 Family
Hole Punch Position.
REP 12.8-110 Stapler Traverse Assembly
Parts List on
PL
12.55.
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Take care not to topple the LCSS. The LCSS is unstable when un-docked from the
machine. Do not show the customer how to un-dock the LCSS.
1.
Un-dock the LCSS,
REP
2.
Remove the rear cover and front door cover assembly,
3.
Manually move the ejector,
4.
Figure
1, Disconnect the harness.
February 2013
4-109
WARNING
GP
14. Disconnect the power cord
WARNING
WARNING
12.13-110.
REP
12.1-110.
PL 12.50 Item 1
fully to the right.
1
Disconnect the group
of 4 connectors.
2
Release the harness
from the clip.
NOTE: For clarity the entry
guide cover (PL12.10 item 3)
has been omitted from this
illustration.
Figure 1 Harness disconnection
REP 12.7-110, REP 12.8-110
Repairs/Adjustments
Advertisement
Chapters
Table of Contents
