Neighbor Add-Path - Dell Z9500 Command Reference Manual

neighbor add-path

This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
Z9500
Syntax
neighbor [ip-address | peer-group-name] add-path [send |
receive | both] path-count
Parameters
ip-address
peer-group-
name
send
receive
both
path-count
Defaults none
Command CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
Related bgp add-path
Commands prefix without the new paths implicitly replacing any previous ones.
408
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group.
Enter the keyword send to indicate that the system sends
multiple paths to peers.
Enter the keyword receive to indicate that the system
accepts multiple paths from peers.
Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
Enter the number paths supported. The range is from 2 to
64.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— allows the advertisement of multiple paths for the same address
Border Gateway Protocol