Management Panel Of A Qfx5100 Device; Figure 15: Qfx5100 Switch, Fru End 1 U Product Skus; Table 9: Network Port Leds On Qsfp+ Ports On A Qfx5100 Switch - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide

Table 9: Network Port LEDs on QSFP+ Ports on a QFX5100 Switch

Color State
Unlit Off
Green On steadily
Blinking
Amber Blinking
Related
Documentation

Management Panel of a QFX5100 Device

32
an optical split cable or a copper DACBO cable.
interpret the QSFP+ LEDs.
Management Panel of a QFX5100 Device on page 32
Installing a Transceiver in a QFX Series Device
Connecting a Fiber-Optic Cable to a QFX Series Device
The management panel of the QFX5100 switch is found on the Field Replaceable Unit
(FRU) end of the switch as shown in
Figure 16 on page 33 for the 2 U , QFX5100-96S switch. See
Figure 18 on page 34 for FRUs and management panel detail.

Figure 15: QFX5100 Switch, FRU End 1 U Product SKUs

1— Management panel
2—Fan modules
Table 9 on page 32
Description
The port is administratively disabled, there is no power, the link is
down, or there is a fault.
NOTE: When configured for 10-Gigabit Ethernet, the LED remains
unlit only if all four of the 10-Gigabit Ethernet SFP+ breakout links
are down.
A link is established, but there is no link activity.
NOTE: When configured for 10-Gigabit Ethernet, the LED is lit green
when at least one of the four 10-Gigabit Ethernet SFP+ breakout
links is established.
A link is established, and there is link activity.
NOTE: When configured for 10-Gigabit Ethernet, the LED is lit green
when at least one of the four 10-Gigabit Ethernet SFP+ breakout
links is established.
All four LEDs blink to indicate the beacon function was enabled on
the port.
Figure 15 on page 32
3— Power supply units
describes how to
for 1 U switches and
Figure 17 on page 33 and
Copyright © 2017, Juniper Networks, Inc.