Ptx5000 Control Board Leds; Figure 13: Control Board Leds; Table 6: Control Board Leds - Juniper PTX Series Hardware Manual

PTX5000 Packet Transport Switch Hardware Guide
Related
Documentation

PTX5000 Control Board LEDs

Table 6: Control Board LEDs

Label Color
MASTER Blue
–
24
Two port LEDs—labeled
indicate the port speed and activity.
NOTE: These ports are reserved for future use.
Gigabit Ethernet SFP fiber-optic or copper port— labeled
the 10-Gigabit Ethernet ports.
NOTE: This port is reserved for future use.
PTX5000 Host Subsystem Description on page 35
PTX5000 Control Board LEDs on page 24
PTX5000 Routing Engine Description on page 44
Maintaining the PTX5000 Control Boards on page 109
Troubleshooting the PTX5000 Control Boards on page 135
Troubleshooting the PTX5000 Host Subsystem on page 138
Three LEDs located to the left of the online/offline button indicate the status of the
control board. Table 6 on page 24

Figure 13: Control Board LEDs

1— MASTER FAIL OK
, , and
2— Y=10/100 G=1000
and
HOST/ETHERNET port
State Description
On steadily Control board is functioning as the master.
Off Control board is functioning as the backup.
and —located below the
LINK ACT
describes the functions of the control board LEDs.
1 2
3— LINK
status LEDs
Ethernet ports labeled
ACT 4— LINK
LEDs for the
port labeled
HOST/ETHERNET
—located to the right of
GE4
3 4
ACT
and LEDs for the 10-Gigabit
(X)GE 0 (X)GE 3
ACT
and LEDs for the Gigabit Ethernet
GE 4
Copyright © 2012, Juniper Networks, Inc.
port