Removing A Power Supply From An Ex4600 Switch; Figure 30: Installing A Power Supply In An Ex4600 Switch - Juniper EX4600 Series Hardware Manual

Related
Documentation

Removing a Power Supply from an EX4600 Switch

Copyright © 2014, Juniper Networks, Inc.
you install power supplies with two different airflow directions, Junos OS
raises an alarm, and the status (
Using both hands, place the power supply in the power supply slot on the FRU panel
3.
of the switch and slide it in until it is fully seated and the locking lever slides into place.

Figure 30: Installing a Power Supply in an EX4600 Switch

NOTE: Each power supply must be connected to a dedicated power source
outlet.
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp
Failure to do so can result in significant delays if you need replacement parts.
This note does not apply if you replace components with the same type of
component.
AC Power Supply in an EX4600 Switch on page 23
Field-Replaceable Units in an EX4600 Switch on page 6
Port Panel of an EX4600 Switch on page 11
Management Panel of an EX4600 Switch on page 9
AC Power Cord Specifications for an EX4600 Switch on page 79
Connecting AC Power to an EX4600 Switch on page 147
Connecting DC Power to an EX4600 Switch on page 149
Removing a Power Supply from an EX4600 Switch on page 169
The power supplies in an EX4600 switch are hot-removable and hot-insertable
field-replaceable units (FRUs): you can remove and replace them without powering off
the switch or disrupting switch functions.
Chapter 20: Replacing Components
) LED blinks amber.
ALM
.
169