Powering On The Dc Powered Ptx5000 Packet Transport Switch; Figure 45: Installing An Input Power Tray - Juniper PTX Series Hardware Manual

PTX5000 Packet Transport Switch Hardware Guide
Related
Documentation

Powering On the DC Powered PTX5000 Packet Transport Switch

96
Close the input power tray cover, and secure it with the screw..
16.
Insert the input power tray into the PDU.
17.

Figure 45: Installing an Input Power Tray

Repeat the procedure for all input power trays in the PDU.
18.
Repeat the procedure for the other PDU.
19.
Verify that the DC power cables are not touching or blocking access to the components,
20.
and that they do not drape where people could trip on them.
PTX5000 Power System Description on page 37
Tools and Parts Required to Provide Power to the PTX5000 Packet Transport Switch
on page 93
Powering On the DC Powered PTX5000 Packet Transport Switch on page 96
To power on the DC-powered PTX5000 Packet Transport Switch:
NOTE: After powering off a power supply, you must wait at least 60 seconds
before powering it on again.
Verify that the power distribution units (PDUs) and power supply modules (PSMs)
1.
are fully inserted in the chassis and that the captive screws on the faceplates are
tightened.
Verify that an external management device is connected to one of the Routing Engine
2.
ports on the control board (
NOTE: The management Ethernet port labeled
control board is not available until after the initial software configuration.
You can monitor the startup process during the initial installation using
devices connected to the
Turn on the power to the external management device.
3.
AUXILIARY or CONSOLE ).
or
AUXILIARY CONSOLE
Copyright © 2012, Juniper Networks, Inc.
on the
HOST/ETHERNET
ports.