Reassigning An Interface To A New Port Channel; Configuring The Minimum Oper Up Links In A Port Channel - Dell Force10 Z9000 Configuration Manual

switchport
channel-member TenGigabitEthernet 1/6
Dell(conf-if-portch)#int Te 1/6
Dell(conf-if)#ip address 10.56.4.4 /24
% Error: Port is part of a LAG Te 1/6.
Dell(conf-if)#

Reassigning an Interface to a New Port Channel

An interface can be a member of only one port channel. If the interface is a member of a port channel, remove it from the first port
channel and then add it to the second port channel.
Each time you add or remove a channel member from a port channel, Dell Networking OS recalculates the hash algorithm for the
port channel.
To reassign an interface to a new port channel, use the following commands.
1. Remove the interface from the first port channel.
INTERFACE PORT-CHANNEL mode
no channel-member interface
2. Change to the second port channel INTERFACE mode.
INTERFACE PORT-CHANNEL mode
interface port-channel id number
3. Add the interface to the second port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
Example of Moving an Interface to a New Port Channel
The following example shows moving the TenGigabitEthernet 1/8 interface from port channel 4 to port channel 3.
Dell(conf-if-po-4)#show config
!
interface Port-channel 4
no ip address
channel-member TenGigabitEthernet 1/8
no shutdown
Dell(conf-if-po-4)#no chann tengi 1/8
Dell(conf-if-po-4)#int port 3
Dell(conf-if-po-3)#channel tengi 1/8
Dell(conf-if-po-3)#sho conf
!
interface Port-channel 3
no ip address
channel-member TenGigabitEthernet 1/8
shutdown
Dell(conf-if-po-3)#

Configuring the Minimum Oper Up Links in a Port Channel

You can configure the minimum links in a port channel (LAG) that must be in "oper up" status to consider the port channel to be in
"oper up" status.
To set the "oper up" status of your links, use the following command.
• Enter the number of links in a LAG that must be in "oper up" status.
INTERFACE mode
minimum-links number
The default is 1.
290
Interfaces