Neighbor Peer-Group (Creating Group) - Dell S6000 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
You can assign up to 256 peers to one peer group.
Information
When you add a peer to a peer group, it inherits all the peer group's configured
parameters. A peer cannot become part of a peer group if any of the following
commands are configured on the peer:
•
•
•
•
A neighbor may keep its configuration after it was added to a peer group if the
neighbor's configuration is more specific than the peer group's, and the neighbor's
configuration does not affect outgoing updates.
A peer group must exist before you add a peer to it. If the peer group is disabled
(shutdown) the peers within the group are also disabled (shutdown).
In BGP, you cannot associate a peer to a peer-group without configuring the
remote-as for Internal BGP (IBGP) or External BGP (EBGP).
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
clear ip bgp
Commands

neighbor peer-group (creating group)

show ip bgp peer-group
show ip bgp neighbors
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
S6000
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Border Gateway Protocol
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
neighbor advertisement-interval
neighbor distribute-list
neighbor route-map
neighbor route-reflector-client
— resets BGP sessions.
— views BGP peers.
— views BGP neighbors configurations.
— creates a peer group.
375