Vlan-Stack Access - Dell Z9500 Command Reference Manual

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Z9500
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
Usage
Prior to enabling this command, to place the interface in Layer 2 mode, enter the
Information
switchport command.
To remove the access port designation, remove the port (using the no member
interface command) from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Z9500
Syntax
vlan-stack compatible
1828
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
VLAN Stacking