Vlan-Stack Access - Dell S6000 Reference Manual

Usage
Information

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
S6000
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
E-Series
original
Command
Usage
Prior to enabling this command, to place the interface in Layer 2 mode, enter the
Information
switchport command.
To remove the access port designation, remove the port (using the no member
interface command) from all stackable VLAN enabled VLANs.
1440
WARNING: The following message displays to confirm the command: All
non-default configurations on the related member ports
ports (<ports listed here>) will be removed. Do you want to
continue (y/n)? If you enter "y", all non-default configurations on any
member ports of the current stack group is removed when the unit is
rebooted.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
VLAN Stacking