Ip Rip Send Version - Dell Z9500 Reference Manual

2
Defaults RIPv1 and RIPv2
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage If you want the interface to receive both versions of RIP, use the ip rip receive
Information
version 1 2 command.
Related

ip rip send version

Commands
version
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the
version command in ROUTER RIP mode.
Z9500
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1
2
Routing Information Protocol (RIP)
(OPTIONAL) Enter the number 2 for RIP version 2.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the RIP version for sending RIP traffic on an interface.
— sets the RIP version the switch software uses.
(OPTIONAL) Enter the number 1 for RIP version 1. The
default is RIPv1.
(OPTIONAL) Enter the number 2 for RIP version 2.
1499