Ip Rip Send Version; Ip Split-Horizon - Dell Force10 S4810P Reference Manual

ip rip send version

Set the interface to send a specific version of RIP. The version you set on the interface overrides the version command
in ROUTER RIP mode.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1
2
Defaults RIPv1
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage To enable the interface to send both version of RIP packets, use the ip rip send
Information
version 1 2 command.
Related
ip rip receive version
Commands
version

ip split-horizon

Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any
routes learned over a specific interface to be sent back out that interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command Modes INTERFACE
1362
(OPTIONAL) Enter the number 1 for RIP version 1. The default is
RIPv1.
(OPTIONAL) Enter the number 2 for RIP version 2.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– sets the RIP version for the interface to receive traffic.
– sets the RIP version to be used for the switch software.