Configuring Access Lists - Enterasys Matrix 2G4072-52 Configuration Manual

14.3.12 Configuring Access Lists

ROUTER: These commands can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to
Purpose
To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and source IP address restrictions.
Commands
The commands used to review and configure security access lists are listed below and described in
the associated section as shown:
•
show access-lists
•
access-list (standard)
•
access-list (extended)
•
ip access-group (Section
(Section 14.3.12.1)
(Section 14.3.12.4)
(Section 14.3.12.3)
14.3.12.4)
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Configuring Access Lists
Section 2.3.3.
14-159