Set System Enhancedbuffermode - Enterasys SecureStack C2 Configuration Manual

set system enhancedbuffermode

Examples
This example shows how to display the system's CPU utilization:
C2(ro)->show system utilization cpu
Total CPU Utilization:
Switch
-----------------------------------------------
1
This example shows how to display the system's overall memory usage:
C2(ro)->show system utilization storage
Storage Utilization:
Type
---------------------------------------------------------------
RAM
Flash
This example shows how to display information about the processes running on the system. Only
partial output is shown.
C2(ro)->show system utilization process
TID
8d45148 captureTask
8e264f8 poe_monitor
8ea6d38 poe_read
8eb7140 vlanDynEg
8f0be10 tcdpSendTask
8f1c0e8 tcdpTask
set system enhancedbuffermode
Use this command to enable or disable enhanced buffer mode, which optimizes buffer
distribution for non‐stacking single CoS queue operation. Executing this command will reset the
switch, so the system prompts you to confirm whether you want to proceed.
Syntax
set system enhancedbuffermode {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
3-14 Basic Configuration
CPU 5 sec
1 3%
Description
RAM device
Images, Config, Other
Name
Enables or disables enhanced buffer mode.
1 min 5 min
1% 1%
Size(Kb) Available (Kb)
262144
31095
5Sec 1Min
0.00% 0.00%
0.00% 0.01%
0.80% 0.22%
0.00% 0.00%
0.00% 0.00%
0.00% 0.00%
97173
8094
5Min
0.00%
0.05%
0.20%
0.00%
0.00%
0.00%