At startup, the SecureStack C2 switch is configured with many defaults and standard features.
This chapter describes how to customize basic system settings to adapt to your work environment.
For information about...
Setting User Accounts and Passwords
Setting Basic Switch Properties
Configuring Power over Ethernet (PoE)
Downloading a New Firmware Image
Reviewing and Selecting a Boot Firmware Image
Starting and Configuring Telnet
Managing Switch Configuration and Files
Clearing and Closing the CLI
Resetting the Switch
Using and Configuring WebView
Setting User Accounts and Passwords
Purpose
To change the switch's default user login and password settings, and to add new user accounts
and passwords.
Commands
The commands used to configure user accounts and passwords are listed below.
For information about...
show system login
set system login
clear system login
set password
set system password length
Basic Configuration
Refer to page...
SecureStack C2 Configuration Guide 3-1
3
3-1
3-8
3-27
3-30
3-32
3-34
3-36
3-45
3-46
3-48
Refer to page...
3-2
3-3
3-3
3-4
3-5