Ip Pimsm Query-Interval; Show Ip Pimsm - Enterasys SecureStack C2 Configuration Manual

Mode
Interface configuration: C2
Example
This example shows how to enable PIM on IP interface for VLAN 1.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm enable

ip pimsm query-interval

This command configures the transmission frequency of hello messages in seconds between
PIM‐enabled neighbors. The no form of this command resets the hello interval to the default, 30
seconds.
Syntax
ip pimsm query-interval seconds
no ip pimsm query-interval
Parameters
seconds
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to set the hello interval rate to 100 seconds.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm query-interval 100

show ip pimsm

Use this command to display system‐wide PIM‐SM routing information.
Syntax
show ip pimsm
Parameters
None.
Defaults
None.
(su)‐>router(Config‐if(Vlan 1))#
This field has a range of 10 to 3600 seconds. Default is 30.
(su)‐>router(Config‐if(Vlan 1))#
ip pimsm query-interval
SecureStack C2 Configuration Guide 17-47