Ip Pimsm - Enterasys SecureStack C2 Configuration Manual

PIM‐SM determines the network topology using the underlying unicast routing protocol to build
a Multicast Routing Information Base (MRIB).
Commands
For information about...
Global configuration commands

ip pimsm

ip pimsm staticrp
Interface configuration commands
ip pimsm enable
ip pimsm query-interval
Display commands
show ip pimsm
show ip pimsm componenttable
show ip pimsm interface
show ip pimsm neighbor
show ip pimsm rp
show ip pimsm rphash
show ip pimsm staticrp
ip pimsm
This command sets administrative mode of PIM‐SM multicast routing across the router to
enabled. IGMP must be enabled before PIM‐SM can be enabled. By default, both IGMP and PIM
are globally disabled. The no form of this command disables PIM (across the entire stack, if
applicable).
Syntax
ip pimsm
no ip pimsm
Parameters
None.
Defaults
None.
Mode
Global router configuration: C2(su)‐>router(Config)#
Note: IGMP must be enabled on all VLANs running PIM-SM, and must also be globally enabled
on the SecureStack C2. For details on enabling IGMP, refer to Chapter 11.
Refer to page...
17-45
17-46
17-46
17-47
17-47
17-48
17-49
17-51
17-51
17-53
17-53
SecureStack C2 Configuration Guide 17-45
ip pimsm