Ip Irdp Broadcast; Show Ip Irdp - Enterasys SecureStack B3 Configuration Manual

ip irdp broadcast

Use this command to configure IRDP to use the limited broadcast address of 255.255.255.255. The
default is multicast with address 224.0.0.1. The no form of this command resets IRDP to use
multicast on IP address 224.0.0.1.
Syntax
ip irdp broadcast
no ip irdp broadcast
Parameters
None.
Defaults
None.
Mode
Interface configuration: B3
Example
This example shows how to enable broadcast for IRDP on the VLAN 1 interface:
B3(su)->router(Config)#interface vlan 1
B3(su)->router(Config-if(Vlan 1))#ip irdp broadcast

show ip irdp

Use this command to display IRDP information.
Syntax
show ip irdp [vlan vlan-id]
Parameters
vlan vlan‐id
Defaults
If vlan vlan‐id is not specified, IRDP information for all interfaces will be displayed.
Mode
Interface configuration: B3
(su)‐>router(Config‐if(Vlan 1))#
(Optional) Displays IRDP information for a specific VLAN. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 16‐1.
(su)‐>router(Config‐if(Vlan 1))#
ip irdp broadcast
SecureStack B3 Configuration Guide 18-13