No Ip Routing - Enterasys SecureStack C2 Configuration Manual

Example
This example shows how to enable VLAN 1 for IP routing:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#no shutdown

no ip routing

Use this command to disable IP routing on the device and remove the routing configuration. By
default, IP routing is enabled when interfaces are configured for it as described in "Configuring
Routing Interface Settings" on page 16‐1.
Syntax
no ip routing
Parameters
None.
Mode
Global configuration: C2(su)‐>router(Config)#
Defaults
None.
Example
This example shows how to disable IP routing on the device:
C2(su)->router(Config)#no ip routing
Reviewing and Configuring the ARP Table
Purpose
To review and configure the routing ARP table, to enable proxy ARP on an interface, and to set a
MAC address on an interface.
Commands
For information about...
show ip arp
arp
ip proxy-arp
arp timeout
clear arp-cache
Refer to page...
16-8
16-9
16-9
16-10
16-11
SecureStack C2 Configuration Guide 16-7
no ip routing