Set Dhcp Conflict Logging; Show Dhcp Conflict - Enterasys SecureStack C2 Configuration Manual

Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables address allocation for BOOTP clients.
C2(rw)->set dhcp bootp enable

set dhcp conflict logging

Use this command to enable conflict logging. By default, conflict logging is enabled. Use the clear
dhcp conflict logging command to disable conflict logging.
Syntax
set dhcp conflict logging
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables DHCP conflict logging.
C2(rw)->set dhcp conflict logging

show dhcp conflict

Use this command to display conflict information, for one address or all addresses.
Syntax
show dhcp conflict [address]
Parameters
address
Enables or disables address allocation for BOOTP clients.
[Optional] Specifies the address for which to display conflict information.
set dhcp conflict logging
SecureStack C2 Configuration Guide 14-5