Set Port Txq - Enterasys Matrix 2G4072-52 Configuration Manual

9.3.3.2

set port txq

Use this command to set QoS transmit queue arbitration values.
set port txq port-string {[value0 [value1] [value2] [value3] [value4] [value5]
[value6] [value7] [value8] [value9] [value10] [value11] [value12] [value13]
[value14] [value15]}
Syntax Description
port-string
value0 - value15
NOTE: The total percentage of transmit queue values must add up to 100%.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to change the arbitration values for the four transmit queues belonging to
fe.2.1:
Matrix(rw)->set port txq fe.2.1 10 30 20 40
Port Priority and Rate Limiting Configuration Command Set
Specifies port(s) on which to set queue arbitration values.
For a detailed description of possible port-string values,
refer to Section
Specifies percentage to allocate to a specific transmit
queue.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Configuring Quality of Service (QoS)
4.1.1.
9-13