Clear Snmp Targetaddr - Enterasys SecureStack B3 Configuration Manual

Defaults
If not specified, udpport will be set to 162.
If not specified, mask will be set to 255.255.255.255
If not specified, timeout will be set to 1500.
If not specified, number of retries will be set to 3.
If taglist is not specified, none will be set.
If not specified, storage type will be nonvolatile.
Mode
Switch command, read‐write.
Example
This example shows how to configure a trap notification called "TrapSink." This trap notification
will be sent to the workstation 192.168.190.80 (which is target address "tr"). It will use security and
authorization criteria contained in a target parameters entry called "v2cExampleParams". For
more information on configuring a basic SNMP trap, refer to "Creating a Basic SNMP Trap
Configuration" on page 6‐36:
B3(su)->set snmp targetaddr tr 192.168.190.80 param v2cExampleParams taglist
TrapSink

clear snmp targetaddr

Use this command to delete an SNMP target address entry.
Syntax
clear snmp targetaddr targetAddr
Parameters
targetAddr
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear SNMP target address entry "tr":
B3(su)->clear snmp targetaddr tr
Specifies the target address entry to delete.
clear snmp targetaddr
SecureStack B3 Configuration Guide 6-27