Set Lldp Tx-Interval; Set Lldp Hold-Multiplier; Show Lldp Port Remote-Info Output Display - Enterasys SecureStack C2 Configuration Manual

set lldp tx-interval

Table 4-5 show lldp port remote-info Output Display
Output Field
Remote Port Id
Device Type
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer
Model Number
Asset ID
set lldp tx-interval
Use this command to set the time, in seconds, between successive LLDP frame transmissions
initiated by changes in the LLDP local system information.
Syntax
set lldp tx-interval frequency
Parameters
frequency
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the transmit interval to 20 seconds.
C2(rw)->set lldp tx-interval 20

set lldp hold-multiplier

Use this command to set the time‐to‐live value used in LLDP frames sent by this device. The time‐
to‐live for LLDPDU data is calculated by multiplying the transmit interval by the hold multiplier
value.
4-22 Discovery Protocol Configuration
What it Displays...
Displays whatever port Id information received in the LLDPDU from the remote
device. In this case, the port Id is MAC address of remote device.
Mandatory LLDP-MED Capabilities TLV. Displayed only when the port is
connected to an LLDP-MED-capable endpoint device.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component.
LLDP-MED Extensions Inventory Management TLV component. In the above
example, no asset ID was received from the remote device so the field is not
displayed.
Specifies the number of seconds between transmissions of LLDP
frames. Value can range from 5 to 32,768 seconds. The default is 30
seconds.