Show Ssl; Set Ssl - Enterasys SecureStack C2 Configuration Manual

show ssl

Defaults
None.
Mode
Switch command, read‐write.
Usage
It is good practice for security reasons to disable HTTP access on the switch when finished
configuring with WebView, and then to only enable WebView on the switch when changes need
to be made.
Example
This example shows how to disable WebView on the switch:
C2(rw)->set webview disable
show ssl
Use this command to display SSL status.
Syntax
show ssl
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display SSL status:
C2(rw)->show ssl
SSL status: Enabled

set ssl

Use this command to enable or disable the use of WebView over SSL port 443. By default, SSL is
disabled on the switch. This command can also be used to reinitialize the hostkey that is used for
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}
3-50 Basic Configuration