Clear Config - Enterasys Matrix 2G4072-52 Configuration Manual

General Configuration Command Set
Resetting the Device
2.2.12.5

clear config

Use this command to clear the user-defined switch and router configuration parameters for one or
more modules. Executing clear config on one Matrix module resets that module back to its factory
defaults. If that module is in a chassis with other active modules, it will inherit system settings from
the system. For a list of factory device default settings, refer to
clear config mod-num | all
NOTE: This command will not affect the IP address.
Syntax Description
mod-num | all
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to clear configuration parameters in all modules:
Matrix(rw)->clear config all
2-156 Matrix DFE-Platinum and Diamond Series Configuration Guide
Clears configuration parameters in a specific module or in
all modules.
Section 2.1.1.