Bdlc State Vector Register (Dlcbsvr) - Mbar + 0X1300 - Freescale Semiconductor MPC5200B User Manual

1 = Stop BDLC internal clocks during CPU wait mode (BDLC_STOP)
0 = Run BDLC internal clocks during CPU wait mode (BDLC_WAIT)
20.7.3.2

BDLC State Vector Register (DLCBSVR) - MBAR + 0x1300

This register is provided to substantially decrease the CPU overhead associated with servicing interrupts while under operation of a MUX
protocol. It provides a index offset that is directly related to the BDLC module's current state, which can be used with a user supplied jump
table to rapidly enter an interrupt service routine. This eliminates the need for the user to maintain a duplicate state machine in software.
msb 0
R 0
W
RESET: 0
READ: any time
WRITE: ignored
—
I[3:0] Interrupt State Vector (Bits 5- 2)
These bits indicate the source of the interrupt request that is currently pending.
BSVR I3
$00 0
$04 0
$08 0
$0C 0
$10 0
$14 0
$18 0
$1C 0
$20 1
The state encoding of the interrupt sources mean that only one interrupt source is dealt with at a time. Once the highest priority interrupt source
is dealt with, if another interrupt event of a lower priority has also occurred, the value corresponding to that interrupt source appears in the
BDLC State Vector Register. This continues until all BDLC interrupt sources have been dealt with and all bits in the BDLC State Vector
Register are cleared.
• Wakeup
The BDLC has two different power-conserving modes, stop and wait. Wakeup from these modes is described below.
• Wakeup from BDLC Wait with CPU in Wait
If the CPU executes a WAIT instruction and the BDLC enters the BDLC wait mode, the clocks to the BDLC as well as the clocks
in the MCU continue to run. The message which generates a Wake-up interrupt of the BDLC and the CPU will be received correctly.
• Wakeup from BDLC Stop with CPU in Wait
If the CPU executes a WAIT instruction and the BDLC enters the BDLC stop mode, the clocks to the BDLC are turned off, but the
clocks in the MCU continue to run. The message which generates a Wake-up interrupt of the BDLC and the CPU will be received
correctly. To ensure this, the EOF following the last message appearing on the bus must be received; otherwise, the message will
not be received correctly.
• Wakeup from BDLC Stop with CPU in Stop
Freescale Semiconductor
BDLC State Vector Register
Table 20-3.
1 2
0 I3
0 0
= Unimplemented or Reserved
Table 1-1. Interrupt Summary
I2 I1 I0
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
0 0 0
MPC5200B Users Guide, Rev. 1
3 4 5
I2 I1 I0
0 0 0
Interrupt Source
No Interrupts Pending
Received EOF
Received IFR byte
Rx data register full
Tx data register empty
Loss of arbitration
CRC error
Symbol invalid or out of range
Wakeup
Memory Map and Registers
6 7 lsb
0 0
0 0
Priority
0 (Lowest)
1
2
3
4
5
6
7
8 (Highest)
20-7