Bestcomm Write; Ata Register Interface; Ata Host Registers—Mbar + 0X3A00; Ata Host Configuration Register—Mbar + 0X3A00 - Freescale Semiconductor MPC5200B User Manual

ATA Register Interface

4. As FIFO fills, BestComm is interrupted and moves data from FIFO to an internal destination.
11.2.2

BestComm Write

1. microprocessor sets up descriptors in BestComm RAM and initiates a transfer.
2. BestComm hits on an ATA command FIFO space and writes a command (ATA drive register address, transfer size) into FIFO.
3. BestComm reads data from internal source and puts data in FIFO
4. ATA Controller transfers data from FIFO and writes to drive.
Any DMA transfer, where source and destination are both on the local bus, requires internal
BestComm SRAM buffering.
11.3 ATA Register Interface
The IPBI module contains all software-programmable ATA Controller registers and the IPB glue logic needed to read and write these registers.
The IPBI registers are listed below. Unless otherwise noted, each register is written and read from the same address.
11.3.1 ATA Host Registers—MBAR + 0x3A00
ATA is controlled by 10 32-bit registers. These registers are located at an offset from MBAR of 0x3A00. Register addresses are relative to
this offset. Therefore, the actual register address is:
Hyperlinks to the ATA Host registers are provided below:
• ATA Host Configuration Register
• ATA Host Status Register
• ATA PIO Timing 1 Register
• ATA PIO Timing 2 Register
• ATA Multiword DMA Timing 1 Register
• ATA Multiword DMA Timing 2 Register
11.3.1.1 ATA Host Configuration Register—MBAR + 0x3A00
msb 0 1
R SMR FR
W
RESET: 0 0
16 17
R
W
RESET: 0 0
Bits Name
0 SMR State Machine Reset—bit resets ATA state machine to IDLE state for PIO, DMA and UDMA
read/write.
1 FR FIFO Reset—bit can be used to reset FIFO when bit 0 of this register is set to reset the
ATA state machine. During normal ATA transaction, FIFO can be reset by setting ATA Drive
Command Register FR bit (see
2:5 — Reserved
11-2
MBAR + 0x3A00 + register address
(0x3A00)
(0x3A04)
(0x3A08)
(0x3A0C)
(0x3A10)
(0x3A14)
Table 11-1. ATA Host Configuration Register
2 3 4 5 6
Reserved IE
0 0 0 0 0
18 19 20 21 22
0 0 0 0 0
MPC5200B Users Guide, Rev. 1
NOTE
• ATA Ultra DMA Timing 1 Register
• ATA Ultra DMA Timing 2 Register
• ATA Ultra DMA Timing 3 Register
• ATA Ultra DMA Timing 4 Register
• ATA Ultra DMA Timing 5 Register
7 8 9 10
IORDY
0 0 0 0
23 24 25 26
Reserved
0 0 0 0
Description
Table 11-29.)
(0x3A18)
(0x3A1C)
(0x3A20)
(0x3A24)
(0x3A28)
11 12 13 14 15
Reserved
0 0 0 0 0
27 28 29 30 31 lsb
0 0 0 0 0
Freescale Semiconductor