Match Interface - Allied Telesis x510-28GTX Command Reference Manual

R M C
OUTE AP OMMANDS

MATCH INTERFACE

match interface
Overview Use this command to add an interface match clause to a route map entry. Specify
the interface name to match.
A route matches the route map if its interface matches the interface name.
Each entry of a route map can only match against one interface in one interface
match clause. If the route map entry already has an interface match clause,
entering this command replaces that match clause with the new clause.
Use the no variant of this command to remove the interface match clause from the
route map entry. Use the no variant of this command without a specified interface
to remove all interfaces.
match interface <interface>
Syntax
no match interface [<interface>]
Mode Route-map Configuration
Usage This command is valid for RIP and OSPF routes only.
To add entry 10 to the route map called mymap1, which will process routes if they
Example
use the interface vlan1, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
To remove all interfaces from the route map called mymap1, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related match ip address
Commands
match ip next-hop
match route-type
match tag
route-map
show route-map
C613-50170-01 Rev B
Parameter
<interface>
configure terminal
route-map mymap1 permit 10
configure terminal
route-map mymap1 permit 10
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The VLAN to match, e.g. vlan2.
match interface vlan1
no match interface
1171